CHASIS 6 WD DISCOUNT
Harga : 9.750.000 Ready Stock It's Here! Now with Video of it in Action on dirt using 34:1 gearboxes and new videos going down and up stairs and over snow with 75:1 gearboxes.
Now available in silver!
Designed originally here on LMR specifically for robots, this 6WD chassis has wicked spiked 120mm dia. wheels and an anodized aluminium chassis made from 2mm thick plate. The chassis has 4mm dia. holes punched every 10mm to allow easy mounting of PCBs, servos etc. All nuts, bolts and screws are stainless steel. Brass fittings and suspension springs are nickel plated.
Two chassis segments between the wheels have been designed to hold 7.2V sub C battery packs (not included) as used in many RC cars. A total of 4x 7.2V battery packs can be fitted if necessary. These batteries are ideal for driving the 6V motors as well as inexpensive linear regulators to supply 5V.
These photos show how even with one wheel resting on a large LMR mug (115mm high) all wheels are still touching the ground. It may not be a rock crawler but that's awesome for an off the shelf robot chassis.
As you can see in this photo, with the top deck fitted you have a smooth deck to mount equipment on even when the chassis is flexed. Mounted on brass hex spacers, the top deck gives you room underneath to hide cables and PCBs to give your robot a cleaner more proffesional finish.
The suspension for the front and rear is a single torsion spring. As the motor housings are connected to each other and not the chassis the front and rear can roll freely with the spring supporting weight and absorbing shock.
The steel cable is used to limit spring travel. The motor housings have 3 holes for each allowing spring tension and travel adjusment depending on the weight of the robot. Rubber grommets are fitted in the spring mounts to eliminate play while allowing the motor housing to roll.
The center suspension is similar but has 2 springs. Each spring connects from the motor housing to the chassis keeping the robot upright.
The 6 powerful geared motors have steel gears and are fitted with powerful magnets to provide high torque. Top speed is about 6.6km/hr. These motors have a maximum stall current of 5.5A each so with 3 motors per side wired in parallel a dual "H" bridge rated for at least 17A per channel is required.
Rated voltage: 6V DC (min. 2V Max. 7.5V)
Stall current maximum 5.5A
No load current per motor is 350mA
Motor RPM is 10000 +/- 5%
Gearbox ratio is 34:1
Output shaft speed is 295rpm +/- 5%
Stall torque is 4Kg/cm
A 75:1 gearbox is now available!
This gives a top speed of about 3Km/hr and a massive stall torque of 8.8Kg/cm per wheel!!!
The chassis comes pre-assembled and weights 2.6Kg.
Now available in 2 colour schemes:
Black with metallic red rims
Silver with chrome rims
I have found that the brass fittings can be a bit tight going into the wheels. You may need to wiggle them a bit as you press them in to ensure they go in all the way otherwise the wheel can sit at an angle making it wobble as it spins.
I hope you have a lot of fun with your new toys :D
I have often been asked how much payload can the chassis handle. The polymorph boxes weight 1.1Kg each. So it can handle as much as 6.6Kg (aprox. 14pound) but I would recommend no more than 5Kg (11pound).
